Highpoint RocketRAID 1740 Betriebsanweisung PDF herunterladen (Seite 59)

FreeBSD Driver Support

7. Before exiting installation, an additional step must be taken to copy the

RocketRAID 174x driver module to the system. On the driver diskette, there is a

setup script labeled “postinstall”, which will complete this task. Before rebooting

the system, press Alt-F4 to enter the command shell, and type the following

commands:

# mount –o ro /dev/fd0 /mnt

# sh /mnt/postinstall

# umount /mnt

Then, press Alt-F1 to return to the setup screen, and choose [X Exit Install] to finish

setup.

2 - Installing the RocketRAID 174x Driver on an Exist-

ing System

If you are currently running FreeBSD and would like to access drives or arrays

attached to the RocketRAID 174x Controller, follow the steps outlined below:

Step 1 Copy the Driver Module

If you have made FreeBSD drivers into a diskette, you can insert the driver diskette to

floppy drive, then using the following commands to copy the driver module:

For FreeBSD 4.x:

# mount –o ro /dev/fd0 /mnt

# cp /mnt/rr174x-xxx.ko /modules/rr174x.ko

# umount /mnt

For FreeBSD 5.x:

# mount –o ro /dev/fd0 /mnt

# cp /mnt/rr174x-xxx.ko /boot/kernel/rr174x.ko

# umount /mnt

Alternately, it is possible extract the files from the .img files directly, without using a

floppy diskette:

6-4

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 65

Keine Kommentare

Highpoint RocketRAID 1740 Betriebsanweisung Seite 59