Highpoint RocketRAID 2640x4 Betriebsanweisung PDF herunterladen (Seite 58)

Linux(Fedora,Red Hat,SuSE) Driver Support

system be able to boot RR26xx controller.

6. Continue the installation as normal. You can refer to Red Hat Enterprise/CentOS

Linux installation guide.

Note:

1. The system device mapping order is the same as the order shown in RR26xx

BIOS Setting Utility.

2. On some system the LILO boot loader may be installed incorrectly unless you

specify BIOS parameters in /etc/lilo.conf. During installation, when prompted

“Would you like to create a boot disk for your system?”, switch to console 2 by

pressing <Ctl>+<Alt>+F2. Then use the following command:

# chroot /mnt/sysimage

# vi /etc/lilo.conf

Add two lines under the line ”boot=/dev/sda”:

disk=/dev/sda

bios=0x80

# /sbin/lilo

Press <Ctl>+<Alt>+F1 to continue the installation.

3 - Installing RR26xx driver on an Existing System

Note:

If you use a SCSI adapter to boot your system, you must make sure the RR26xx

controller BIOS will be loaded after that adapter’s BIOS. If not, try to move it to

another PCI slot. Otherwise you may be unable to boot up your system.

Step 1 Obtain the Driver Module

You can extract the module file from the file modules.cgz on the driver disk. Using the

following commands:

# mount /dev/fd0

# cd /tmp

# gzip -dc /mnt/floppy/modules.cgz | cpio -idumv

6-12

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 83 84

Keine Kommentare

Highpoint RocketRAID 2640x4 Betriebsanweisung Seite 58