Highpoint RocketRAID 2640x4 Betriebsanweisung PDF herunterladen (Seite 74)

FreeBSD Driver Support

for FreeBSD 6.3-RELEASE

ok load disk0:rr26xx-6.3.ko

for FreeBSD 6.3-AMD64-RELEASE

ok load disk0:rr26xx-6.3-amd64.ko

for FreeBSD 7.0-RELEASE

ok load disk0:rr26xx-7.0.ko

for FreeBSD 7.0-AMD64-RELEASE

ok load disk0:rr26xx-7.0-amd64.ko

5. After the driver has been loaded, remove the floppy diskette from the floppy

drive.

6. Type in “boot” and continue the installation as normal. You can refer to FreeBSD

installation guide.

ok boot

Note: On some systems with ACPI enabled, FreeBSD may not work. You can try to

disable ACPI in system BIOS or type the command “set hint.acpi.0.disabled=”1””

under boot prompt to solve the problem.

7. Before exit install, an additional step must be taken to copy RR26xx driver module

to system. On the driver disk, there is a setup script “postinstall” which will do

this work for you. Before you reboot the system, press Alt-F4 to the command

shell and type the following commands:

# mount –o ro /dev/fd0 /mnt

# sh /mnt/postinstall

# umount /mnt

Then press Alt-F1 to return to the setup screen and choose [X Exit Install] to finish.

Note: On some systems the floppy may be inaccessible during installation. In this

case, please remove the CD, reboot from the installed system and load the driver

manually from floppy again when booting from controller. After system boots up you

can run the postinstall script to install the driver.

7-5

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 83 84

Keine Kommentare

Highpoint RocketRAID 2640x4 Betriebsanweisung Seite 74